Twitter IconFacebook IconBathtubs and Sinks-Repairing and Refinishing in Medford

Cabinet Paint Instructions For Painting Cabinets

Please Print These Directions

Warning

PROVIDE ADEQUATE VENTILATION. WEAR A SOLVENT RATED RESPIRATOR OR MASK WHEN APPLYING. USE LATEX GLOVES AND PROPER CLOTHING WHEN HANDLING PAINT, PRIMER AND ADDITIVES. FOLLOW MANUFACTURES DIRECTIONS AND AVOID BREATHING VAPORS. IF YOU OR ANYONE IN YOUR HOME HAS RESPIRATORY HEALTH PROBLEMS OR ASTHMA, DO NOT USE THIS PRODUCT. EXTINGUISH ALL IGNITION SOURCES. DO NOT SMOKE WHILE USING. FLAMMABLE.

REPAIRS Must be completed prior to using this product. Chips, cracks, cuts, peeling paint, holes or other damage.

DIRECTIONS

STEP 1 – PREPARING THE CABINETS

A. Use products at room temperatures above 60 degrees only. The preparation of the cabinets is the most important step in the refinishing process. Follow directions completely. May be applied by brush, roller or hvlp spray system.

B. Surface must be clean, dry and free from grease, oils or other debris. Cabinets must be sanded with 100 grit sandpaper to rough up the surface and aid in adhesion of our paint coatings. Wipe laminate, melamine and solid surface cabinets down with Acetone.

C. If cabinets have been waxed, remove the wax by rubbing the cabinets with Acetone prior to sanding.

* All hardware should be removed whenever possible or mask these items with tape prior to painting.

STEP 2 – Applying The Primer Bonder

Primer – Mix thoroughly. Apply the primer by foam brush, or roller. Typically one light coat is required.

Primer will be dry to the touch in approximately 1-2 hours depending on temperature and humidity. If second coat is required, make sure primer is completely dry before applying a second coat. Allow primer to dry completely before applying the high gloss top coat..

STEP 3 – Applying The High Gloss Color Coating

A. Mask off plumbing fixtures, walls, or any other surfaces not being refinished.

B. Mix thoroughly.

Do not try to apply paint all at once. One coat is all that is required. If a second coat is needed make sure coating is completely dry by waiting 24 hours depending on temperature and humidity before applying another coat.

Avoid runs, If you do get any runs, wipe the paint off with a paper towel lightly saturated with acetone. When finished, remove masking tape and paper. Do not allow fixture to dry with masking tape or paper left on it. Be careful not to get debris on wet coating. Allow to Dry 24 hours – DO NOT USE THE FIXTURE OR ALLOW THE PAINTED AREA TO GET WET FOR 24 HOURS.

Clean Up with paint thinner and dispose of brushes, rollers and other materials properly. Keep out of reach of children and do not allow children in the work area.

USE THESE PRODUCTS AT YOUR OWN RISK.
The Bathtub Refinishing Referral Network will not be liability for incidental or consequential damages, arising from the use, or misuse of these products. Any claims regarding these products must be directed to the manufacturer. Product received damaged during shipment must be reported to the shipping company within 24 hours of receipt of damaged goods and the Bathtub Refinishing Referral Network must be notified at sales@refinishingonline.com .

Returns: Any item returned due to damage in shipping or a defective item, must receive an Identification tag, prior to shipping the item back to the supplier. Tag is only available by emailing the Bathtub Refinishing Referral Network at the above email address. We must be contacted within 24 hours of receiving a damaged or defective item. No item will be accepted without an ID tag. Refunds will include replacement of the damaged or defective product only and are provided from the manufacturer.

This product is dangerous if misused. The customer or enduser(s) assume full responsibility for its proper use and application, as outlined in these installation instructions. Material Safety Data Sheets (MSDS) are available upon request –contact: sales@refinishingonline.com .